Resources
Installation Guide
General installation planning notes for hammered, etched and aged decorative metal sheets and panels. Final method should be confirmed by the project-side installer.
This page does not claim on-site installation service. Use it as general guidance only.
General Guide
Plan installation around surface protection, substrate review, and project conditions.
Use these notes as conversation prompts. They are not a replacement for project drawings, installer review, or finish-specific confirmation.
Review the material before installation
- Check product type, finish direction, protective film notes, panel size, and visible surface orientation before site work.
- Review any approved sample or reference panel before confirming the installation direction.
- Confirm compatibility with the project substrate, fixing method, and site condition before use.
Plan handling and protection
- Use clean handling surfaces and avoid dragging decorative faces across hard or rough materials.
- Keep protective film and surface protection approach under review depending on finish and project requirements.
- Confirm edge, corner, cutting, and fabrication notes before any site adjustment.
Coordinate with project-side installers
- Final installation method should be confirmed by qualified project-side installers based on site condition and application.
- Adhesive, mechanical fixing, backing board, joint, and ventilation decisions should be reviewed before installation.
- Mockup review is recommended where visual direction, lighting, or handmade variation may affect the final appearance.
Project Confirmation
Confirm installation approach before site work.
Hammered, etched and aged decorative surfaces can respond differently to lighting, handling, substrate, fixing method, and finish direction. Review samples or mockups where the visual result is important.
For project questions, send the surface type, application, dimensions, substrate notes, and installer questions through the sample request route.
Installation Review
Start with one sample before final installation planning.
Share your application, size, base material, hammered / etched / aged finish direction, and project notes so the surface direction can be reviewed before deeper planning.